SKILL LEVEL beginner
by Dremel ®
1Tape Measure or Yard Stick
1Drill with 1/4" drill bit
1A Section of 1/4 in. Plywood (I used a scrap I had laying around, about 20 x 23", which gave me about 20 tags in all)
1Chalkboard Paint and Roller
Let's Get Started
To reduce the risk of injury user must read instruction manuals for all tools used in this project. Wear eye and respiratory protection. Use clamps to support work piece whenever practical.
Paint your sheet of plywood with chalkboard paint (both sides optional). Do at least two coats.
Measure and mark strips with chalk (I chose to mark strips at 3 in).
Clamp the painted sheet to a table, then clamp a 1" board along your first mark. Use your Dremel Saw-Max (with the flush cut wheel) to cut your first strip. Repeat.
Stack painted strips and measure/mark how wide you want your tags to be (I chose 5.5 in). Making sure all edges are aligned, clamp the Dremel Miter Guide to your stack and the worktable. Make your cut, repeat.
Drill holes in upper corners. If you choose to stack tags when drilling, be sure to align the edges carefully and clamp the tags to the table to avoid slipping (I usually don't stack and drill more than 3 or 4 tags at a time).
Sand the edges of your tags with the Dremel Multi-Max.
Now grab your tags, some jute twine, and run... (Because your neighbors are gonna want 'em!)
A TOOL THAT CAN DO IT ALL
Experience Dremel's most powerful oscillating tool. Featuring 7.0 amps of power and 2 new, powerful cutting blades, the Dremel Velocity is the only tool you need.
TOUR THE MAKER GALLERY
Explore the creations added to the Maker Gallery by Dremel Makers.